Mission

Conveyor 04 Stopped

Conveyor 04 runs for about four seconds after a start command, then faults and stops. The line has been down for twenty minutes and the pack hall is backing up. Production want it running; your job is to find out what is actually wrong before you change anything.

CONV-04 · PACK HALL · LINE 2

Elapsed 00:00

MOTOR SPEED MISMATCH

Active alarm · line stopped

Machine: CONV-04
State: FAULTED
Cmd speed: 850 mm/s
Actual speed: 610 mm/s
Drive: READY / NO FAULT
Run time: 4.1 s
Motor temp: 48 °C
E-stop string: HEALTHY

Investigate

Information

Electrical

Controls & feedback

Mechanical

Intervention

Action log

0 entries

No actions logged

Every investigation costs time. Choose the order deliberately — you are scored on it.

Submit diagnosis

You can call it at any point. Submitting ends the mission and is scored on the evidence behind the answer, not only on the answer.

Glazed drive pulley lagging — the belt is slipping under loadEncoder coupling slipping on the shaftEncoder has failed or is miscountingVFD output fault or incorrect drive parametersMotor winding fault or a lost phasePLC speed-comparison logic is mis-scaled